![]() Se hai seguito questa strada, vorresti impostare l'uscita sul PC almeno al 50% per iniziare, per assicurarti che venga inviato un segnale sufficiente a Sonos. La sfida lì, specialmente con un jack per cuffie, sarà sempre il "livello" dell'uscita dal PC, che è variabile dall'impostazione del volume sull'uscita del PC. Tuttavia, se stai utilizzando l'uscita analogica dal PC, come potresti fare con una presa per le cuffie, probabilmente vorrai saltare la digitalizzazione come passaggio aggiuntivo e utilizzare solo i jack RCA analogici sull'amplificatore. Se stai usando quella porta ottica, è già digitale e non funzionerebbe per essere ridigitalizzata da un DAC. Ma dipende dal segnale che ricevi dal PC. I can still trigger a library update from my macbook but not my work pc. My work pc and various phones/tablets are 9.2. No, my hardware is 9.1 along with my macbook. If you went that route, you’d want to set the output on the PC at least to 50% to start, to ensure that enough signal is getting sent to the Sonos. Even if you could, your system is at 9.2, which disables the same menus when using older versions of the controller. The challenge there, especially with a headphone jack, will always be the “level” of the output from the PC, which is variable by the volume setting on the PC’s output. However, if your using the analog output from the PC, such as you might with a headphone outlet, you’d probably want to skip the digitizing as an extra step, and just use the analog RCA jacks on the Amp. If you’re using that optical port, it’s already digital, and wouldn’t work to be re-digitized by a DAC. But it depends on which signal you’re getting from the PC. Lo único que puedo hacer es indicarle las preguntas frecuentes de Sonos para usar una línea en. Es probable que sea mejor que hables directamente con el soporte de Sonos y no conmigo. Si eso no ayuda, intente reducir la frecuencia, pero como dije, no estoy lo suficientemente familiarizado con la PC para brindarle una guía inteligente allí, lo siento. Apague el audio DTS, no puede viajar a través de una conexión óptica. Una cosa me llama la atención ya que está utilizando un cable óptico que tiene un ancho de banda limitado. ![]() The only other thing I can do is point you to the Sonos FAQ for using a line in. You’d likely be better talking with Sonos Support directly, and not me. If that doesn’t help, try reducing the frequency, but as I said, I’m not familiar enough with the PC in order to give you much intelligent guidance there, sorry. Turn off DTS audio, it can not travel through an optical connection. One thing jumps out at me since you’re using an optical cable which has limited bandwidth. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |